Description
This Sandvik D55SP drill, located in Western Australia, is in excellent condition after undergoing a full and comprehensive ground-up rebuild in 2017. The rebuild resulted in an enhanced system with better-quality pumps and motors that provide more power and pressure. Additionally, a state-of-the-art electronics system was installed for full system monitoring and a superior engine management system was put in place, allowing the operator to have real-time updates on the engine and hydraulic system temperatures and fuel consumption reports.
We have included photos of the drill from 2017 when the rebuild was just finished, so you can see the quality of the work done. A full specification on this drill, as well as a Sandvik standard D55SP specification document, can be found under the documents tab.
Sandvik D55SP Technical Data
Hole diameter
172mm-254mm (6¾” – 10”)
Drill pipe
7.62m (25’)
Hole depth extension)
17m (55’) single pass (+ 15.2m (50’)
Undercarriage
330SL class excavator
Max pull-down
200 kN (45,000 lbf)
Bit load
232 kN (52,000 lbf)
Engine
597 kW (800hp)
Compressor
345.3 m/min (1600 scfm) 6.9 bar (100PSI)
Feed rate
0-35.4m/min (0-116 fpm)
Hoist rate
0-61.6 m/min (0-202 fpm)
Rotation speed
0-131 RPM
Rotation torque
9934 Nm (88,000 in-lb)
Operating weight
79,832 kg (176,000 lb)
630
Rebuild Specifications -
Sandvik-D55SP
Sandvik D55SP Service History -
ComponentStatus Rig 59 REPORT
Prices displayed are exclusive of GST.
Buyer is responsible for transport arrangements and cost from Seller's location once payment has cleared.
All information on this website including but not limited to general equipment description, location and photographs has been provided to Rig Sales Australia by third parties (Sellers) who we believe are reliable and have given the information in good faith.
However, in displaying the information on this website, Rig Sales Australia, has done no more than pass it on. Rig Sales Australia has not formed an opinion as to whether the information contained on the Website is correct, they have not verified the information and they cannot guarantee its accuracy. Rig Sales Australia and its employees can not be held responsible for any description information on this website or for relaying the information via verbal or digital communications.
The information contained on the website must not be solely relied upon and you should make your own inspections and seek specialist advice which is specific to your circumstances in respect of any equipment on the website.
Listings displayed on the website are current at the time of issue, but may change at any time at the Sellers discretion without notice.
No price negotiation will take place until a formal, in person inspection has taken place by the potential buyer. Only then can a offer be submitted in email form to our office (
[email protected]) which Rig Sales Australia will present to the Seller. An emailed offer does not constitute a contract. Sales Agreements are only drawn up once all parties are in agreement.
